Pete,

Actually section 4.3.1 states "of each type of material processed..."  See the following:

4.3.1 Coupon Selection - Two sets of test coupons of the most complex pattern of each type of material processed during the inspection period shall be selected from lots that have passed acceptance testing.

With that said, what is the definition of "each type of material"?  Is this based on resin system type, e.g., epoxy versus polyimide (which I think was the intent), or each of the various types, e.g., FR406, FR408, IS-410, 370 HR, 4000-12, 4000-13, etc., which would really be impractical.

Regards,
Scott A. Bowles
Director of Engineering and Quality
Hallmark Circuits, Inc.
13500 Danielson Street
Poway, CA 92064
 
858-513-2200 Phone
858-513-2233 Fax
858-437-7827 Cell
 

-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]]
Sent: Monday, September 08, 2008 10:29 AM
To: [log in to unmask]
Subject: [IPC-600-6012] Quality Conformance Testing IPC-6012 Para. 4.3


All:

IPC 6012 has a requirement for  monthly conformance testing but it does
not state what material should be tested - 

Under the military specifications
(MIL-P-55110/MIL-PRF-31032/MIL-P-50884) a manufacture running both
polyimide and epoxy resins would be required to submit samples of both
material types each month unless the requirement is tailored (31032
allows tailoring).

What is the groups opinion? Should this be addressed in some manner - or
is it addressed and I'm missing it?

Thanks,



Pete Menuez
Supplier Quality Manager
L-3 Communications Cincinnati Electronics
7500 Innovation Way
Mason, Ohio 45040
[log in to unmask]

513-573-6401 Voice
513-573-6767 Fax