Wendi,

The spacing requirement is in IPC-2222, Section 10.1.1.

Randy
 
Randy Reed, CQE
Reliability Lab
Viasystems Group Inc.
[log in to unmask]
 
503.992.4421-direct  l   503.545.0150-cell

-----Original Message-----
From: IPC-600-6012 [mailto:[log in to unmask]] On Behalf Of Wendi
Boger
Sent: Friday, March 12, 2010 8:11 AM
To: [log in to unmask]
Subject: [IPC-600-6012] Edges and Crazing/Haloing

Everyone,

 

   I seem to remember a discussion about Haloing of edges and non plated
holes at one of our recent meetings.   The requirement for the haloing
to be less than 50% the distance to nearest conductor works assuming the
design has a reasonable space from conductor to edge.  I looked in
IPC2221 but did not find a guideline for suggested minimum distance.  We
are seeing non-plated tolling holes with surface ground rings at <10mils
hole edge to copper.  Depending on the material and hole size it's
difficult to meet the 50% rule.  

 

   Is there a section in 2221 I can send the designers to so we can
avoid this type of issue?

 

Thanks,

Wendi Boger

 


 
This communication is for use by the intended recipient(s) only and may
contain information that is privileged, confidential, proprietary and
exempt from disclosure under applicable law. You are hereby notified
that any dissemination, distribution, forwarding or copying hereof is
strictly prohibited without the express written consent of DDi. If you
have received this communication in error or are not the intended
recipient, you should destroy the message and any attachments or copies,
and you are prohibited from retaining, distributing, disclosing, or
using any information contained herein. Please inform us of the
erroneous delivery by return e-mail. Thank you for your cooperation. 

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or
[log in to unmask] 
______________________________________________________________________

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________