Dear Designers
Can anyone of with Mentor Graphics experience help me on that.
I received a package from a customer stating that he uses the orcad as
his schematic capture and PADS as his PCB backend.
My mission is to use this orcad netlist to route and place the required
board on Mentor boardstation. The data he sent me was (*.net, *.olb,
*.dsn), how am I going to use these files to go on to layout ?
Is there a white paper or a known hand-on experience that I can use ?
Need Advice.
Thank You and have a nice day.
--
Best Regards
Khaled H. Fouad
==========================================
Manager, PCB Design Division
Research & Development Department
Tel.:+2011333414 Ext. : 312
Fax.:+2011335613
BAHGAT Group (http://www.bahgat.com)
Email : [log in to unmask]
==========================================