Most board shops couldn't handle what you are proposing, but if you gave
your bare boards to a machine shop they would have no problems with your
design.

-----Original Message-----
From: Susy Webb [mailto:[log in to unmask]]
Sent: Wednesday, February 06, 2002 12:58 PM
To: [log in to unmask]
Subject: [DC] routing the thickness of a board


I've got a good one for the gurus out there!

And engineer just asked me if a rigid board could have an area (an edge
actually) routed such that the overall area of the board is one thickness
(.125), and the routed area is another (.062) See the side view picture
below...


routed area
          \   __________________
        _____|                  |
.062    |_______________________| .125



Other than the obvious issues of controlling routing depth, and I imagine a
hugh cost, what else should I be concerned about? Can it even be done??? We
were thinking that it might be easier to build two boards and fuse them into
one, but would the alignment problems kill that idea?

TIA for any help,
Susy

Susy Webb, CID
Sr PCB Designer
Carlo Gavazzi Computer Systens
281-875-1500 x33
[log in to unmask]

----------------------------------------------------------------------------
-----
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET
DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------