Hi,

 Sorry for the late notice but we've had to replace our
original speaker on short notice due to scheduling
conflicts. We'll meet Thursday night with pizza from
6:30 to 7:30; followed by a viewing of an IPC video
tape on Solder Paste procedures and a short business
meeting from 7:30 to 9:30. The meeting will be held at ASE
[directions below.] Please let me know by tomorrow afternoon
if you'll be able to attend.

See you there,

Tom

Thomas G. Martin, Vice President
Smoky Mountain Chapter, IPC Designer's Council
Work: [log in to unmask]  865-330-1526
6721 Baum Dr; Knoxville, TN 37919-7314
Home: [log in to unmask]  865-428-4312

Directions to ASE :
          FROM  I-40 West:
          Take the Papermill Pike exit (exit 383),
          Turn left on Papermill Pike,
          Turn left on Northshore Drive (1st traffic light)
          follow "BOTH" below,

          FROM  I-40 East :
          Take the Papermill Pike exit (exit 383),
          Come straight through the intersection after exiting I-40
          (You are now on Northshore Dr.),
          follow "BOTH" below,

          BOTH:
          On Northshore Drive,
          Cross Kingston Pike and go under the railway trestle,
          Turn right on Baum Dr. (1st traffic light after the trestle),
          Turn right at the "Renaissance Business Center" sign
          (approximately 1/2 mile , if you cross the railroad track you've
gone
          too far),
          Turn immediately left into the parking lot.
          The cafeteria entrance to ASE is on the right end of the
building.