Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Mon, 14 May 2001 17:06:41 +0300 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dear John
Thanks for your concern,but I think these clearances for axial and dip
components only,is it right?
A.Sunhoury
Pcb Designer
> ----------
> From: John Coy[SMTP:[log in to unmask]]
> Sent: Monday, May 14, 2001 3:44 PM
> To: 'DesignerCouncil E-Mail Forum.'; 'Ahmed El-Sanhoury'
> Subject: RE: [DC] Radial Components
>
> HI AHMED
>
> TRY IPC2221-8-1 PAGE 48 FIGURE 7-1
> I THINK THIS WILL ANSWER ALL YOUR QUESTIONS
>
> JOHN COY
> PLEXUS
>
> -----Original Message-----
> From: Ahmed El-Sanhoury [ mailto:[log in to unmask]]
> Sent: Monday, May 14, 2001 2:06 AM
> To: [log in to unmask]
> Subject: [DC] Radial Components
>
>
> Dear All
> I am looking for any standard talks about the tooling clearances for
> automatic radial components assembly,
> (i.e between each radial components, radial component and board
> edge,finally
> between radial component and mounting hole), thanks in advance.
>
> A. Sunhoury
> Pcb Designer
> www.bahgat.com
>
> --------------------------------------------------------------------------
> -------
> DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
> 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
> To set a vacation stop for delivery of DesignerCouncil send: SET
> DesignerCouncil NOMAIL
> Search previous postings at: www.ipc.org > On-Line Resources & Databases >
> E-mail Archives
> Please visit IPC web site ( http://www.ipc.org/html/forum.htm) for
> additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
> ext.5315
> --------------------------------------------------------------------------
> -------
>
>
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|