Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Fri, 20 Feb 2004 08:25:44 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I have made 1/2 a plated thru hole ON the board edge... I don't believe
there is any restriction on hole to edge spacing but there are good design
practices that we all follow. That should not stifle a designers creativity
in solving packaging challenges. A non-plated hole is typically used for
tooling or mounting... Some boards break out the hole like a slot in the
corners...
I don't believe we are restricted in 'hole to edge' spacing by any specs,
plated or non-plated.
Bill Brooks
PCB Design Engineer , C.I.D., C.I.I.
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510
-----Original Message-----
From: Frank A Bergmeister [mailto:[log in to unmask]]
Sent: Friday, February 20, 2004 4:15 AM
To: [log in to unmask]
Subject: [DC] drill hole to board edge ...
Can anyone quote the spec for how close a nonplated thru hole can get to
the board edge. I know the rule of thumb, but I need to see something in
writing.
Thanks
----------------------------------------------------------------------------
-----
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET
DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
----------------------------------------------------------------------------
-----
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|