Subject: | |
From: | |
Reply To: | |
Date: | Wed, 11 Jun 1997 08:16:48 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi,
I've been very lucky to use FR4 or better material. The next batch of
pcb I will layout will be FR2 or FR1 for mass production(1-3000 per
month). I am looking for design rule suggestions that I am not familiar
with or gotchas for these cheap materials. Example min/pref annular ring
on for pads-hole, min/preferred trace width, via placement for epoxy,
etc.
Any help will be appreciated -- thanks in advance,
Scott Shepard
***************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text.*
***************************************************************************
* If you are having a problem with the DesignerCouncil, please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|