Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Wed, 6 Feb 2002 14:11:00 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I don't think they need to "route" the step - I believe they can do this by
using creative lamination techniques. (laminate a layer of .062 onto
another of a different dimension)
-Denis
At 11:58 AM 2/6/2002 -0600, you wrote:
>I've got a good one for the gurus out there!
>
>And engineer just asked me if a rigid board could have an area (an edge
>actually) routed such that the overall area of the board is one thickness
>(.125), and the routed area is another (.062) See the side view picture
>below...
>
>
>routed area
> \ __________________
> _____| |
>.062 |_______________________| .125
>
>
>
>Other than the obvious issues of controlling routing depth, and I imagine a
>hugh cost, what else should I be concerned about? Can it even be done??? We
>were thinking that it might be easier to build two boards and fuse them into
>one, but would the alignment problems kill that idea?
>
>TIA for any help,
>Susy
>
>Susy Webb, CID
>Sr PCB Designer
>Carlo Gavazzi Computer Systens
>281-875-1500 x33
>[log in to unmask]
>
>---------------------------------------------------------------------------------
>DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
>1.8d
>To unsubscribe, send a message to [log in to unmask] with following text in
>the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
>To set a vacation stop for delivery of DesignerCouncil send: SET
>DesignerCouncil NOMAIL
>Search previous postings at: www.ipc.org > On-Line Resources & Databases >
>E-mail Archives
>Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
>information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
>ext.5315
>---------------------------------------------------------------------------------
>
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|