> Would someone with a copy of IPC-T-50 please tell me what the diff is
> between an unsupported hole and a supported hole?
Hi George!
Supported hole: A hole in a printed circuit board that has its
inside surfaces plated or otherwise reinforced.
Unsupported hole: A hole in a printed circuit board that does
not contain plating or other type of reinforcement.
Hope this helps!
JoAnn L. Amerson
Design Librarian
Red Lion Controls, Inc.
E-mail: [log in to unmask]
Voice: (717) 767-6961 ext 6308
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################