I Have run into a problem in creating meaningful symbols for resistor packs in
PowerLogic.  Showing all resistors together as one symbol is not a problem.
However, ther are many instances where individual resitors within a pack are
scattered all over the schematic and a single symbol is not practical.  I have
tried everything that I can think of to draw and package individual resistors
within a pack that be be used separately, so that I do not get error reports
on the netlist or problems when impoting the netlist into PCB.  I also need an
intelligent database in order to run circuit simulation routines.  Does anyone
have an answer or workaround for me.

Thank,
Helpless in Silicon Valley
[log in to unmask]

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################