Sometimes there is a requirement to remove the marking on a chip after assembly or even before assembly. 
What sort of issues come from this activity? 
Is there a company that is expert at doing this that could contract to do this? 
If we did it in house, what equipment and expertise would we need? 
Where should I look to for advice? 

 
Bill Brooks | Datron World Communications, Inc.
PCB Designer/Engineer | Office: 760-602-7004| Fax: 760-597-3777 | [log in to unmask]
3055 Enterprise Court, Vista, CA 92081 | www.dtwc.com
Performance You Require. Value You ExpectTM

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------