0.039370078

-----Original Message-----
From: Huffman, Tony [mailto:[log in to unmask]]
Sent: 23 October 2000 18:09
To: [log in to unmask]
Subject: [DC] True conversion


I am looking for the true mm to inch conversion. Webster defines a mm as
being .0394 inches but the conversions I see on drawings do not agree with
this. Where can I find the definitive conversion formula? Any ideas?
TANX!

> Tony G. Huffman
> PC Board Layout Specialist
> Hunter Engineering Company
> 11250 Hunter Drive
> Bridgeton, Mo. 63044
> [log in to unmask]
> (314)731-0000 ext.330
> (314)731-9932 FAX
> http://www.hunter.com
>
>

----------------------------------------------------------------------------
-----
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------