Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Sat, 16 Jan 1999 09:51:48 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi everyone,
We are an assembly company that uses pre-baking of the flex
substrates (Kapton and polyimide) as part of our pre-production
process. We're planning to eliminate this process as part of our cost
reduction. What will be the effect with regards to its
assembly and reliability. The flex is use for cameras, is there any
effect on the type of product it is being used. Are there any
technical bulletin or standards that will suffice our plan. Any
inputs regarding this matter will be highly appreciated.
Regards,
Edwin Maximo
Value Engineer
Electronic Assemblies Inc.
Edwin Maximo
Value Engineer
Electronic Assemblies Inc. Phils.
phone no - (632) 823 7317
fax no - (632) 759 8629
email - [log in to unmask]
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|