Good discussion... It seems from your comments that others have experienced this 'phenomenon'... and found ways to accommodate the wishes of their customers, or management as the case may be...
I also have added mechanical and other non-electrical parts to the schematic on a 'junk' page to make them show up in the BOM for the board... sometimes they have footprints and sometimes they don't...
Examples of items that may or may not belong on the BOM that aren't electrical are things like fiducials, mounting holes, tooling holes, brackets, card ejectors, stiffeners, heat sinks, sil-pads, nylon washers and screws to isolate TO-220 transistors, some mounting terminals, clips for fuses, standoffs, spacers, etc...
William Brooks, CID+
Senior MTS (Contract)
2747 Loker Ave West
Carlsbad, CA 92010-6603
760-930-7212
Fax: 760.918.8332
Mobile: 760.216.0170
E-mail: [log in to unmask]
_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
This email is intended only for the use of the party to which it is addressed and may contain information that is privileged, confidential, or protected by law. If you are not the intended recipient you are hereby notified that any dissemination, copying or distribution of the email or its contents is strictly prohibited. If you have received this message in error, please notify us immediately, by replying to the message and deleting it from your computer.
WARNING: Internet communications are not assured to be secure or clear of inaccuracies as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Therefore, we do not accept responsibility for any errors or omissions that are present in this email, or any attachment, that have arisen as a result of e-mail transmission.
_____________________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 16.0.
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
