Subject: | |
From: | |
Reply To: | |
Date: | Mon, 10 May 1999 10:56:01 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
From my PCB house (Nashua Circuits, Nashua NH) - I'll stand with them as their
product is excellent.
Regards,
Bob Landman
H&L
-
>Bob,
>
>I have no data to support our beliefs, but here goes!
>
>We remove non-functional pads off internal signal layers as standard
>procedure for processing inner layers. We have done this for about
>4 years now and haven't had any complaints about barrel cracks or
>through hole pull away. The copper that would remain after the drill
>process is very small. The only thing the copper adds is more drill wear
>and the increased likelihood of shorts between copper pads that have
>no electrical responsibilities whatsoever.
>
>In the absence of any data available to us we stand with Mr Lomax.
>
>George
>
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|