Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Wed, 30 Sep 2009 12:51:35 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Tracy -
Try the Machinists' Handbook for drilling tolerances. For general purposes +/-3mil for holes less than 125mil and +/-5mil for holes greater than 125mil will work. Make sure you indicate whether you are specifying finished hole or drilled hole condition.
Jeffrey A McGlaughlin, CID
Engineering Designer
Battelle
505 King Ave
Columbus Ohio 43201-2693
Phone (614)424-7582
-----Original Message-----
From: DesignerCouncil [mailto:[log in to unmask]] On Behalf Of Tracy Norton
Sent: Wednesday, September 30, 2009 12:36 PM
To: [log in to unmask]
Subject: [DC] drill tolerance
I just got caught in an embarrassing situation. A client pointed out
that I don't have drill tolerance specified on my fab notes, and wants
it added AND referred to the specific IPC standard
I looked back at all my work as far back as to '98...and there's no
drill dia tolerance callout!
All I need is pointed to specific standard so I can research it and add
to notes
Thanks!
Tracy Norton
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|