Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Thu, 18 Feb 1999 09:12:49 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
+/- 10% is standard, and must be specified either as MMC/LMC or
show actual tolerance at nominal dimension
-----Original Message-----
From: Jack Olson [mailto:[log in to unmask]]
Sent: Wednesday, February 17, 1999 7:39 PM
To: [log in to unmask]
Subject: [DC] PCB thickness & tolerance
This is such a lame question, but:
I can't seem to find the reference in IPC documents
regarding board thickness and tolerance,
Except in IPC-D-275 5.2.4 it says
"Board thickness shall be specified on the master
drawing and unless otherwise specified, shall include
metallic deposition"
I have always heard the tolerance should be +/-10%
(.062 +/- .007, for example)
But I can't find it! help.....
Jack
p.s. If someone specified a thickness as ".093 nominal"
what would be acceptable on incoming inspection?
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC
using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask]
with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line
Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask]
or 847-509-9700 ext.312
################################################################
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|