Hello,
Some of our PCB suppliers have ask if the could use Entec
instead HASL. Especially PCBs with 'press in technique' and
mounding and soldering by hand are objects of our concern.
Has anyone experience with Entac used with 'press in
technique' and/or mounding and soldering by hand
Thanks in Advance.
--
mfg Oliver Gundolf
------------------------------------------------------------
| Lucent Technologies |
| Abt. LB33 (PCB-Engineering)| Thurn-und-Taxis-Strasse 10 |
| D-90411 Nuernberg | Deutschland / Germany |
| Name: Oliver Gundolf | Fax: +49-911-526-3328 |
| Telephon: +49-911-526-3916 | E-Mail: [log in to unmask] |
| Responsibilitys: Layout access and switching PCB |
------------------------------------------------------------
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################