Hi Everyone,

I am using OrCad Layout for PCB design and create the fabrication drawing in AutoCad as follows:

1. Run Post Processor to extract Drill Drawing (board outline, hole symbols, and drill chart) from OrCad Layout, resulting in a DXF file.

2. Open DXF file in AutoCad and add necessary board dimensions @1/1 scale.

3. I then select all and create a Block, and then scale 1.5/1.

The problem is when I explode the block to make any changes, the dimensions do not remain at the 1/1 scale, but change to whatever I scaled the block as.
Ex. 1/1 dim=10.000, when exploded, dimension=15.000. What can I do to prevent this? If I don't create a Block first before scaling, the dimensions conform to the scaling factor and do not remain 1/1.

Thanks in Advance,

Mike

Mike Clemente, C.I.D.
Sr. PCB Design Specialist
dZinit Applied Technologies
Tel: 847-545-8170
Fax: 847-545-8175
Email: [log in to unmask]

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To set a vacation stop for delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------