Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Wed, 10 May 2000 09:56:32 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Mark,
It is always best to check with your vendor for a question like this as it is
driven mostly by their process capabilities.
Regards,
Bill Gebhardt, C.I.D.
Electrical Engineer/PCB Designer
Overland Data, Inc.
San Diego, CA
Mark Mainland <[log in to unmask]> on 05/10/2000 09:24:12 AM
Please respond to "DesignerCouncil E-Mail Forum." <[log in to unmask]>;
Please respond to Mark Mainland <[log in to unmask]>
To: [log in to unmask]
cc: (bcc: Bill Gebhardt/ENG/SanDiego/US)
Subject: [DC] Traces
I was curious if someone knows how narrow of a trace can I
go until it affects board costs? I have been using 8 mil as a rule.
Thanks
Mark Mainland
PCB Designer
Cherry Electrical Products
11200 - 88th Ave.
PO Box 581913
Pleasant Prairie, WI 53158
Ph. 262.942.6659
Page. 888.819.0198
Fx. 262-942-6334
********************************************************************
To learn more about Overland and its products, visit us at:
http://www.overlanddata.com
********************************************************************
|
|
|