Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Tue, 9 Feb 1999 12:56:00 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
This is the design guide I follow, that was specified to me by a vendor.
It is not based on any standard that I know of, but it has worked
perfectly everytime so far (meaning many many times).
On a .062" board, the 30 degree score cut in from both sides is .021"
deep, leaving a center section .020 +/- .004". I leave .030" free space
from the score edge. On the .031" boards that I do, the numbers are
halved, except for the tolerance.
Hope this helps some.
Richard
-----Original Message-----
From: Paul Brionez [SMTP:[log in to unmask]]
Sent: Monday, February 08, 1999 12:55 PM
To: DesignerCouncil
Subject: [DC] Board to Component Clearance for Sc
I would like to know what the minimum spacing that you use in
designing a board that will be scored for component clearances.
Quality has a question?
Thanks in advance.
Paul Brionez
Sr. PCB Designer
Cherry Electrical Products
11200 88th Ave
P.O. Box 581913
Pleasant Prairie, WI 53158-0913
PH 414-942-6659
Fax 414-942-6334
Pager 414-318-9964
[log in to unmask]
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using
LISTSERV
1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following
text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|