Subject: | |
From: | |
Date: | Tue, 6 Aug 1996 07:50:05 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We have used it for single sided boards and we found the Z expansion to be
excessive. I would suspect plating vias would not be very reliable once
thermal expansion started. I recommend speaking with your board vendors as
they should have reliable data to go by. -Ed Current
----------
From: Barry Olney[SMTP:[log in to unmask]]
Sent: Monday, August 05, 1996 6:41 PM
To: [log in to unmask]
Subject: CEM1 Substrate material
Has anyone used CEM1 substrate material? Can CEM1
be plated through?
I believe it is a low cost material that is used
in the mass production of comsumer products.
Holes are punched rather than drilled.
Thank you in advance for your help.
___________________________________________________
Barry Olney http://www.icd.com.au
Managing Director
In-Circuit Design Pty Ltd Ph: +61 3 9205 9595
VeriBest Solutions Centre Fax:+61 3 9205 9410
Suite 211, Princess Tower Mbl:+61 4 1117 0827
1 Princess Street,
Kew, VIC 3101, Australia Email:[log in to unmask]
___________________________________________________
************************************************************************
****
* The mail list is provided as a service by IPC using SmartList v3.05
*
************************************************************************
****
* To unsubscribe from this list at any time, send a message to:
*
* [log in to unmask] with <subject: unsubscribe> and no text.
*
************************************************************************
****
****************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05 *
****************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
****************************************************************************
|
|
|