Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Fri, 5 Feb 1999 15:24:31 -0000 |
Content-Type: | multipart/alternative =_NextPart_001_01BE511B.A0D50EA0" |
Parts/Attachments: |
|
|
Thanks,
That should get me started !
Regards;
Derek
Derek Here's a few guidelines
- Keep via pattern on your routing grid
- If device uses local fiducials (fine pitch devices) make sure they're
in place
prior to putting in pattern.
- Keep fan-out traces (stringers) .008 min.
Fine pitch traces keep .003 smaller than pad size
- Keep fanout pads .040 min. from component largest feature (pad or
comp. body)
(if possible, for testability)
- Make sure you don't connect pad 2 to pin 3 (depends on type of
software)
- Keep gnd inside of pattern and pwr on outside (depends on where caps
are)
Hard to give example with limited keys;
1 --- = 2
/ <--- routing channel
=--/
3 --- = 4
/ <--- routing channel
=--/
^ ^ ^ ^ ^
| | | | |______ pad (via)
| | | |________ trace
| | |___________ smt pad
| |______________ trace
|_________________ pad
Michael Kuczynski Librarian/Sr. Designer
Allied Signal 201-393-2122 (Phone)
699 Rt46E E/K4 201-393-2357 (Fax)
Teterboro NJ 07608
[log in to unmask]
[log in to unmask]
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using
LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
|
|
|