Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Thu, 18 Feb 1999 08:36:24 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
While +/- .008 is typical (for an .062 board), its a good idea to check
the (possibly more restrictive) tolerance requirements of any edge
connectors that the board is mating into, or of any 'stradle' mount
connectors on the board. Of course this often seems to be missing from
connector data sheets, so a call to the mfg may be required. For
example, the AMP Mictor right-angle (stradle mount) recepticle requires
a thickness tolerance of +.008/-.005.
Gary Crowell
Micron Technology
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|